
Ginsan under soft cladding, ebony in the hand.
Ginsan Santoku 180mm

New
Ginsan (Silver 3) · Kasumi
In stock · Ships from Prague
Every blade on this site gets its own trading card - tier-colored, kamon-stamped, and built around the seven specs that actually predict how the knife behaves on the line. Steel. Hardness. Edge. Length. Handle. Finish. Origin.

Ginsan under soft cladding, ebony in the hand.

The marked part of the edge is the part doing the work.
The edge is nearly flat, so most of it meets the board at once.
A short pull toward you takes meat and fish through the whole edge.
The low tip stays close to the board, so the front third does the fine dicing.
The wide flat of the blade carries the cut food off the board.
Ground on both sides, it cuts straight and suits either hand.
Handle
A Japanese wa handle: one piece, fitted over a hidden tang.

Drag to turn
Steel
59-61 HRC
Use and care
Ginsan (Silver 3) is stainless, so care takes three steps.
Boneless cuts only; long roasts need a longer blade.
Fits a board of 30 to 40 cm.
The flatter edge cuts straight down and resists rocking.
Never the dishwasher.
Standing water marks even stainless.
A saya for storage. A stone for the edge. An oil for the steel.

1000-grit waterstone. The workhorse grit for kitchen edges.

Camellia (tsubaki) oil. Food-safe. A thin pass keeps the steel quiet.
“Ginsan Santoku 180mm is the three-virtues home blade - flat enough for push-cuts, short enough to clear a domestic board. Ginsan (Silver 3) sits comfortably in the working range of a Japanese kitchen blade, running at HRC 59-61. In the kitchen, that means it asks less of your wrist than a gyuto and still does everything a non-professional kitchen needs. It sits in our catalog because it earns its keep on a working line, the geometry is honest, and the steel is what the maker said it is. We've held it. That's what gets a knife on this site. ”
- Ethan
Yes - the chromium content in the steel passes a thin oxide layer over the surface that resists rust under normal kitchen use. You still hand-wash and dry it like any good knife (no dishwasher, no soaking), but you don't need the daily oil-wipe routine a carbon blade needs.
No knife you care about should go in a dishwasher. The heat warps the handle, the detergent dulls the edge, and clattering against other dishes chips the bevel. Hand-wash with warm water and a soft sponge, then dry immediately.
HRC stands for "Rockwell Hardness, scale C" - a measurement of how hard the steel is. Higher numbers mean the steel holds an edge longer but is also more brittle. This knife is 59-61 HRC, which is the working sweet spot for Japanese kitchen blades.
Use a Japanese waterstone. 1000-grit for regular sharpening, 5000-grit for finishing. Soak the stone if it needs soaking (most modern Shapton-style stones are splash-and-go), hold the blade at around a 15-degree angle to the stone (a folded coin makes a decent gauge), grind one bevel until you raise a burr along the entire edge, flip and do the other side. Finish with light alternating strokes to remove the burr. Steer clear of pull-through sharpeners - they tear the edge.
We ship from our EU warehouse in Prague. Free across the EU on orders over 2.000 Kč, ~3-5 business days. Outside EU: standard rates apply, customs handled at destination. Tracking on every order.
Unused items in their original condition can come back within 30 days of delivery for a full refund. Email office@smartsushichef.com first and we send you the return address. Arrived damaged or wrong? Tell us within 48 hours and we pay the return shipping.
Pick one more to compare side by side.